#Udp to tcp bridge serial#

The IP address entered for the bridge will need to be entered in RMCWin, as described below. IP Address, Subnet Mask, and Default Gateway: The same guidelines laid out in Understanding IP Addressing for selecting an RMC ENET's IP parameters apply when selecting a bridge's IP parameters. This will include the following settings: The second main set of settings you will need to configure in the bridge is the TCP/IP interface. Therefore, it will not need to deal with initiating connections or setting up a specific remote IP address.

#Udp to tcp bridge serial#

In addition to these basic serial settings, there are often many other options for the serial interface. The following serial settings must be used to communicate with the RMC: These bridges are typically designed to be very flexible, and as a result can be fairly confusing to set up. Most of the work in setting up this driver involves configuring the bridge device. Therefore, if the port on the bridge is DTE, then a cross-over cable should be used otherwise a straight-through cable should be used. The bridge will be connected to the RMC's 'RS-232 Monitor' serial port using an RS232 cable. How this is done depends on the particular bridge device, but in most cases will involve using a CAT5 Ethernet cable to connect the bridge to a hub or switch on the LAN that will be used. If multiple RMCs will be hooked up using the same method, it may be worth investing in a multi-port bridge, so that a single bridge can handle several RMCs.Д¬onnect the Bridge to the Ethernet Network

The RMC has been tested with the Lantronix (UDS-10. A search on the Internet for 'Ethernet to Serial Converter' should find a number of manufacturers providing these devices. There are a number of TCP/IP-to-RS232 bridge devices available. The main steps to configuring a TCP/IP-to-RS232 Bridge communication path are as follows: Note: This communication driver requires RMC100 CPU firmware dated 20010522 or later. Communication Driver: TCP/IP-to-RS232 Bridge Configuration Communication Driver: TCP/IP-to-RS232 Bridge Configuration